Ptz - EverFocus ECOR960 4F2 User Manual

ALL the FIGURES in the following chapters and sections are using the OSD of ECOR960 16F2 DVR
as examples; the only one difference among the three models of the ECOR960 DVR is the numbers
of channels which are 4, 8 and 16 respectively. Therefore, if there are settings relating to camera
channels on the OSD menu, the number of channels appeared on your OSD should be equal to the
4-channel, 8-channel or 16-channel DVR that you purchase.

4.1 PTZ

You can use the PTZ Control Panel to control the connected PTZ cameras. To bring up the PTZ
control panel, on the OSD Root Menu, click the PTZ button
The following actions can be performed using the PTZ Control
Panel:
1. To move the camera to the desired direction and angle,
click the Direction buttons.
2. To zoom in / out the camera view, click the Zoom buttons.
3. To adjust the camera focus, click the Focus buttons.
4. To adjust the Iris open to increase / decrease the amount of
light in, click the Iris buttons.
5. To program a Preset Position (if supported by the camera):
a. Move the PTZ camera to the desired position.
b. Click the Preset button.
c. Set up a preset number for the current position by
clicking the number buttons. The number will be
displayed in the number box.
d. Click the Set button to save the settings.
6. To jump to a Preset Position:
a. Click the Preset button.
b. Click the desired Preset number.
c. Click the Go button.
7. Shortcut for Preset 1 ~ 9:
a. Click digit 1 ~ 9 button without clicking any other
buttons.
b. The camera will seek that Preset Position.
Note
.
39
ECOR960 4F2 / 8F2 / 16F2
Figure 4-2