Troubleshooting & Faq; Using The Telnet Terminal Commands - Draytek Vigor2000 User Manual

Troubleshooting & FAQ
The following section explains how to use Telnet terminal commands
to diagnose your network problems via the built-in debug tool. Our
examples use Windows Telnet client software. If you are a Mac user,
you should install third-party Telnet client software on your computer.
By default, the Linux has a built-in Telnet client.

8.1 Using the Telnet Terminal Commands

Click Start -> Run and type "Telnet 192.168.1.1" in the Open box as
below. Note that the IP address in the example is the default address
of the Vigor2000 router. If you have changed the default, enter the
current IP address of the router.
Click "OK". The Telnet terminal will open. If an administrator password
has not been assigned, follow the on-screen instructions to assign
one.
8-2