Snapshot Mode Timeout
Parameter # 323
This parameter sets the amount of time the digital scanner remains in Snapshot Mode. The digital scanner
exits Snapshot Mode when you pull the trigger, or when the Snapshot Mode Timeout elapses. To set this
timeout value, scan the bar code below followed by a bar code from
default value is 0 which represents 30 seconds; values increment by 30. For example, 1 = 60 seconds, 2 = 90
seconds, etc.
Snapshot Aiming Pattern
Parameter # 300
Select Enable Snapshot Aiming Pattern to project the aiming pattern when in Snapshot Mode, or Disable
Snapshot Aiming Pattern to turn the aiming pattern off.
*
Enable Snapshot Aiming Pattern
(1)
Image Cropping
Parameter # 301
This parameter crops a captured image. Select Disable Image Cropping to present the full 752 x 480 pixels.
Select Enable Image Cropping to crop the image to the pixel addresses set in
page
6-8.
Enable Image Cropping
(1)
Imaging Preferences
Appendix D, Numeric Bar
Snapshot Mode Timeout
Disable Snapshot Aiming Pattern
(0)
Crop to Pixel Addresses on
*
Disable Image Cropping
(Use Full 752 x 480 Pixels)
(0)
6 - 7
Codes. The