Scanner Emulation Parameter Defaults; Scanner Emulation Host - Motorola DS6878 Reference Manual

Scanner Emulation Parameter Defaults

Table 12-1 lists the defaults for the Scanner Emulation host. To change any option, scan the appropriate bar
code(s) provided in the Scanner Emulation Host Parameters section beginning on
NOTE See
miscellaneous default parameters.
Scanner Emulation Default Table
Table 12-1
Parameter
Beep Style
Parameter Pass-Through
Convert Newer Code Types
Module Width
Convert All Bar Codes to Code 39
Code 39 Full ASCII Conversion
Transmission Timeout
Ignore Unknown Characters
Leading Margin
Check for Decode LED
1
User selection is required to configure this interface and this is the most common selection.

Scanner Emulation Host

Scan the bar code below to enable the Scanner Emulation host.
Undecoded Scanner Emulation Host
Appendix A, Standard Default Parameters
Beep on Successful Transmit
Parameter Process and Pass Through
Convert Newer Code Types
20 µs
Do Not Convert Bar Codes to Code 39
Disable
3 sec
Ignore Unknown Characters
2 ms
Check for Decode LED
Scanner Emulation Interface 12 - 3
for all user preferences, hosts, symbologies, and
Default
page 12-4.
Page Number
12-4
12-5
12-6
12-6
12-7
12-7
12-8
12-9
12-9
12-10