The Shaft Assembly - Minelab EXPLORER II User Manual

Explorer ii metal detector
Hide thumbs Also See for EXPLORER II:
Table of Contents

Advertisement

THE SHAFT ASSEMBLY

The shaft assembly is made up of the upper and lower shafts connected by the shaft
camlock. The assembly houses the coil cable and connects the search coil to the
handle assembly. These instructions assume that the search coil is connected to the
lower shaft.
Camlock Released
Figure 2.4
Feeding coil cable into upper shaft
Search Coil
Shaft Camlock
Upper Shaft
Figure 2.5
Sliding lower shaft into
upper shaft
P0601-A
Shaft assembly
Figure 2.4, 2.5
To assemble the lower and upper shaft:
CAUTION
Release the shaft camlock lever before inserting
the lower shaft.
(Figure 2.4) Feed the coil cable which is inside the lower
STEP 1
shaft through the inside of the upper shaft.
P0602-A
(Figure 2.5) Slide the lower shaft entirely into the upper shaft
STEP 2
until the camlock rests against the yoke.
Pull the coil cable's metal connector through the open end of
STEP 3
the upper shaft until it 'dangles' from the opening.
You are now ready to connect the shaft assembly to the
handle assembly.
THE MINELAB EXPLORER II
THE SHAFT ASSEMBLY
21

Advertisement

Table of Contents
loading

Table of Contents