Table of Contents
Advertisement
THE MINELAB EXPLORER II
www.minelab.com
28
REPLACING AND FITTING THE SEARCH COIL
(Figure 2.15) Gently pull the coil cable from inside the yoke/
STEP 4
lower shaft.
(Figure 2.16). Carefully feed the coil cable of the new coil
STEP 5
back into yoke and lower shaft. Continue to feed the cable
into the shaft unitl the connector is visible at the top of the
shaft.
Note: It may be easier to pull the cable through the lower
shaft using a length of string or cord. Once this is completed
you should be able to see approximately 4 inches (100mm)
of cable between the coil yoke and the search coil. This is
the slack necessary to allow adjustment to the angle of the
search coil.
Re-attach the yoke and the search coil. Be careful not to
STEP 6
damage the thread of the nut by over-tightening. See Figure
2.2 and 2.3.
Reconnect cable to control box (as directed in Connecting
STEP 7
the shaft assembly, page 16).
Pull Coil Cable
up inside of
yoke/shaft
Figure 2.16 Removing the coil cable
P0613-A
Advertisement
Table of Contents
