Table of Contents
Advertisement
Instruction Manual
5.
Assembling the Detector
Please follow these instructions to assemble the Sovereign Elite. Refer
to the drawings to identify parts and how they are positioned. Please
contact your Minelab dealer for further instructions should any
difficulties arise.
5.1
Armrest/Upper Shaft Assembly
a) Place the two arm rest halves (4) on
either side of the upper shaft (2) and
ensure that the bolt hole is aligned.
b) Slide the nylon bolts through the bolt
holes and screw the nylon wing nuts
(12) onto the bolts with a couple of
turns (do not tighten).
c) Slide the detector stand (7) into the
runners of the arm rest (4) and tighten the nylon wing nuts by hand.
d) Attach the arm rest straps (6) using the press studs on both sides of
the arm rest.
e) Push the arm rest straps through the slots in the arm rest cover (5) and
push the cover over the arm rest.
5.2
Lower Shaft Assembly
a) Remove the tape on the lower fibreglass
tube (3) that is holding the black teardrop
washers (10) in place.
Note: Ensure the washers do not fall out
after removing the tape.
b) Remove the black nylon wing nut (12), and
bolt (11) from the coil (9).
c) With the teardrop washers in place, push the
lower tube (3) into the coil bracket so that the holes line up.
6
4
12
5
7
Figure 2 - Armrest/upper
shaft assembly
3
10
11
Figure 3 - The coil and
lower shaft assembly
Page 9
2
4
6
11
P0570-A
12
9
P0044-B
Advertisement
Table of Contents
