Table of Contents
Advertisement
THE MINELAB EXPLORER II
www.minelab.com
Figure 2.2
bracket
Figure 2.3
coil
20
CONNECTING THE SEARCH COIL
STEP 3
STEP 4
STEP 5
You are now ready to proceed to the shaft assembly.
P0605-A
Inserting coil yoke into
P0606-A
Securing yoke to search
Check the orientation of the search coil and shaft ensuring
that the open side of the yoke faces the ground.
(Figure 2.2) To join the shaft to the search coil, slide the
yoke into the yoke bracket on top of the coil.
(Figure 2.3) Insert yoke bolt through the search coil's yoke
bracket and the coil yoke. Fasten with the yoke nut
provided, being careful not to damage the thread of the nut
by over-tightening. This may need to be loosened to adjust
the coil to a comfortable detecting angle.
Advertisement
Table of Contents
