Completing The Shaft Assembly - Minelab Excalibur 800 Instruction Manual

Instruction Manual
d) Push the black nylon bolt (11) through the holes in the bracket on the coil
from the cable entry side, then place the wing-nut on the other end of the
bolt and tighten it by hand.
Figure 4 - Excalibur with shaft assembled for Diver's Mode

Completing the Shaft Assembly

a) Slide the lower shaft assembly into the upper metal shaft. Note that the
black plastic twistlock nut (14) may need to be loosened to get the lower
shaft assembly in place.
b) Begin winding the coil cable firmly around the shaft by rotating the lower
black stem. Wind between 25 and 28 turns of the cable until it reaches the
control cylinder.
c) Set the length of the shaft by locking the spring clip into one of the 3 holes
provided, and then tighten the plastic locking ring by hand.
NOTE:
Leave enough slack at the bottom of the cable near the coil to adjust the
coil position without straining the coil cable.
Page 11