Completing The Shaft Assembly; Shaft Mount - Minelab Musketeer ADVANTAGE Instruction Manual

Page 8

Completing the Shaft Assembly

a) Slide the lower shaft assembly (5) into the upper shaft (3). Note that the
black plastic locking nut (9) may need to be loosened to get the lower shaft
assembly in place.
b) Set the length of the shaft by locking the stainless steel spring clip into one
of the holes provided, then tighten the plastic locking ring by hand.

Shaft Mount

a) Position the control box so that the recess
in the control box (11) is aligned with the
leading edge of the mounting clip (12).
Push the foward section of the control box
upwards until the trigger "clicks" indicating
the control box is secured.
b) Firmly wind between 17 and 20 turns of
the cable around the shaft until it reaches
the control box.
NOTE:
Leave enough slack at the bottom of the cable near the coil to adjust the
coil position without straining the coil cable.
c) Connect the cable connector (10) to the plug on the rear of the control box.
d) Use Velcro tabs to secure cable in the correct position on the shaft
maintaining slack at coil and control box
Figure 3 - Completing the shaft assembly
The Minelab Musketeer Advantage
Figure 4 - Mounting the
control box