Smart Sonic Receiver; Adjusting Sound Quality (Clear Call) - AU K012 Basic Manual

Smart Sonic Receiver

Your K012 is equipped with a "smart sonic receiver" that
transmits sound by the display vibrating. So while the
receiver does not have holes for sound, you use it in a usual
manner. Hold the K012 firmly against your ear as shown
during a call, use Collect Sound, etc.
■
Holding the Receiver to Your Ear
Hold the K012's receiver area against your ear as shown,
so that it covers your ear and blocks surrounding sound
to make calls more audible. Adjust the position of the cell
phone up or down, left or right to suit your set sound quality
and surroundings.
Receiver
Microphone
34
• Do not cover the K012's microphone with your cheek
or fingers during a call.
• If an earphone (sold separately) is connected, sound
switches from the smart sonic receiver to earphone
sound.
• Do not place stickers or sheets over the display. May
affect receiver sound.
• Audibility varies with each person.
• Audibility differs depending on surroundings.
Adjusting Sound Quality (Clear
Call)
Clear Call allows you to adjust sound from the K012 so it is
more audible.
You should set "Clear Call" in a quiet place.
When the standby screen is displayed, press
c28 and then c.
➡ Hold the K012's receiver against your ear, and
then adjust while listening using u/d or
+/-.
➡ Press c.
• "Clear Call" works for sound during calls/while using
Collect Sound.
• "Clear Call" is temporarily canceled during handsfree
calls.