Wiring The Fan Coil Unit For Power - Wine Guardian SS025 Installation, Operation And Maintenance Manual

Wiring the Fan Coil Unit for Power

The electrical outlet and wiring installation must meet the national and local
DO:
 Match the electrical wiring to the cord provided on the Wine Guardian. 
 Provide dedicated circuit and wiring for the system.
 Match the wiring and breaker size to the rated load as shown on the serial
plate and in this guide. See sample serial plate illustration below.
Electrical
Evaporator Fan Amps
Total Unit Amps (w/o opt.)
Min. Circuit Amps (w/o opt.)

Air Innovations, 7000 Performance Drive, North Syracuse, New York 13212
Ph:800-535-3295 * 315-452-7400 * Fax: 315-452-7420
.
DO NOT:
 DO NOT MODIFY THE PLUGS IN ANY WAY! 
 Do not use extension cords.
The electrical power supply must be either 115 volt or 230 volt AC 1 phase 60 cycle, depending
on the model of the unit, and cannot vary more than plus or minus 4% or damage may occur
Plug the unit into the wall outlet. Gently pull on the plug to make sure it is tight.




Neutral
ELECTRICAL SHOCK HAZARD
RISK OF SERIOUS INJURY OR DEATH
building codes.
Model# SS088
230/1/60
0.8
0.8
1
IMPORTANT
to the unit.
DANGER
Serial# 11L18342
Electric Heat Amps
(opt.)
Humidifier Amps (opt.)
Crankcase Htr. Amps.
Refrigerant
Test Pressure
6.7
0.3
0.2
R-134-A
275psi

31