Split System Interconnecting Line Sizing Chart - Wine Guardian SS025 Installation, Operation And Maintenance Manual

quarter inch, a vibration eliminator should be installed close to the motor compressor in a
horizontal parallel to the compressor, crankshaft or in a vertical position 90 degrees to
compressor crankshaft.
NOTE: The suction line should be clamped near the inlet end of the vibration
eliminator. The vibration eliminator is located between the clamp and the
.
compressor

Split System Interconnecting Line Sizing Chart

Table 3
Model Liquid
Line(OD)
1/4"
SS025
1/4"
SS050
SS088 3/8"
3/8"
SS200
*Interconnecting tube must be reduced down at evaporator connection
Notes:
Line lengths are expressed in equivalent feet = actual run length + fitting allowances (i.e. ~5' for
each bend/elbow allowance).
Use only refrigeration grade dehydrated tubing.
Install refrigeration piping per local codes and ASHRAE guidelines.
Liquid Suction
connection line (OD)
at
evaporator
(OD)
1/4" 3/8"
1/4" 1/2"
*1/4" 1/2"
3/8" 7/8"
Min. Suction
Suction line connection
insulation at
thickness evaporator
(in) (OD)
3/8" 3/8"
3/8" *3/8"
5/8" 1/2"
5/8" *1/2"
Maximum Maximum
"total" line lift
length (height)
50' 15'
50' 15'
50' 15'
50' 15'
33