Deletion Function; Error Messages - Olympia CM 811 Quick Reference

Quick Reference
To operate in Training mode:
Set the key to REG
Note: No reports can be printed in Training mode.
End Training mode:
Set the key to PRG
5
Press
q
pressing

Deletion function

Caution: The following steps should only be taken when you are familiar with the programming functions.
Initiate a warm start
A warm start deletes the last malfunction. The programming is retained.
Set the key to PRG. Disconnect the power plug.
Then press the
The cash register prints PARTIAL RESET.
Delete all reports
All sales are deleted. The programming is retained.
Set the key to PRG. Disconnect the power plug. Then press the
while reconnecting the power plug.
The cash register prints REPORT RESET.
Delete all data
All programming and sales are deleted. The cash register is reset to its default, factory settings.
Set the key to PRG. Disconnect the power plug. Then press the
while reconnecting the power plug.
The cash register prints FULL RESET.

Error messages

Error messages appear in the display in the case of incorrect operation.
Error message Cause
E
Wrong key pressed.
PAPER
End of paper
EJ FULL
The electronic journal is full.
A password has been programmed
SEC-CODE
for Z-reports.
A password has been programmed
SEC-CODE
for the clerk.
Request for report printout of the
CL
electronic journal with key in posi-
tion Z.
Olympia 8.2005
CM 811/812 Cash Register
6 times, conclude by
.
g 7
and keys simultaneously while reconnecting the power plug.
Input
555555 5555,55
Corrective measure
g
Press .
Insert new paper roll, press
Delete the electronic journal (with or without printout).
Enter the 4-digit password, press
Enter the clerk number. Then enter the 3-digit password.
Conclude by pressing
Delete the electronic journal by pressing
Or: Clear the error message by pressing
Page 17
Quick Reference
Display Confirm by pressing
g 7 9
, and keys simultaneously
g 3 7
, and keys simultaneously
g
.
n
.
Q
.
g
S
All Rights Reserved
q
.
.