Dash Cooler; Stern Seat Center Cushion; Fuel Tank Location; Boarding Platform Removal - CORRECT CRAFT Ski Nautique Owner's Manual

box. This "clam-shell" design allows you to check the engine without lifting
the entire engine box. You can leave the top open to dry the bilge.

Dash Cooler

The dash cooler can be used to store misc. items or drinks. There is a drain
installed in this box. Do not depend on this cooler to keep valuables or
electronics dry. We suggest keeping these type of items in a specialized dry
bag.

Stern Seat Center Cushion

The stern seat center cushion can be removed to to get in and out of the boat.
Stern Seat Trunk Storage
The stern seat back may be lifted vertically to expose a storage area. If you
have the optional electric actuator, use the "up" and "down" keys on the
keypad to raise and lower the stern seat back. In the event there is no power
from the battery, remove the two bolts at the top of the stern seat back. The
seat back can be lifted to gain access to the trunk.
Stern Seat Base Removal
The stern seat base is not intended to be removed except to service the fuel tank.
If your boat does not have a trunk, the stern seat base is removable. Lift both side
cushions and locate the latches under the cushions. Flip the handle on the latches under
the cushions. There is a stanchion from the floor to the deck behind the coaming pads
on both sides of the boat. There are two rubber latches that hold the front of the stern
seat base to these stanchions. After these latches have been released, the stern seat base
can be lifted straight up.

Fuel Tank Location

The fuel tank is located beneath the stern seat and the trunk area. To inspect
the hose connections, raise the stern seat back and remove the inspection plate
in the trunk. If you boat is not equipped with a trunk then the fuel tank is
located directly behind the removable stern seat base and back.

Boarding Platform Removal

Pull the two pins that are located in the mounting brackets and lift the platform
vertically. Make sure to keep the pins attached to the brackets on the platform
so you don't lose them. If you misplace these pins, contact your dealer for a
replacement set.

Battery Location

The battery is located under the floor in front of the in-floor cooler.

Optional Electric Sensor in Drainplug

The optional Electronic Sensor in Drainplug "senses" when the drainplug is
installed. When the drainplug is not installed in the drain, an alarm will sound
1.13