Receiver Rear View - AMX DXLink Multi-Format Wallplate Instruction Manual

Receiver Module LEDs
HDMI RX Indicator LEDs
LED
Power
Video
Audio
Scaling:
– Bypass
– Auto
– Manual
IR TX
IR RX
Serial TX
Serial RX
NetLinx Link/Act
NetLinx Status
CEC
USB
* When the output cable is disconnected from the HDMI RX or if no EDID can be found on the destination device,
the last used Scaling Mode LED will be ON. In either case, the HDMI RX will continue to hold its output resolution to the last
known preferred resolution until a power cycle or reconnection of a sink with a valid EDID. On power up without a valid
EDID, the default preferred output resolution presented will be 1280x1024 @ 60 Hz until a different EDID is detected.
Note: For detailed behavior of the NetLinx Link/Act and Status LEDs on the module's front, see page 62.
For detailed behavior of the RJ-45 connectors' LEDs on the module's rear, see page 50.

Receiver Rear View

Power jack
Ground screw
FIG. 9
HDMI RX rear view
The following components are located on the rear of the HDMI RX (left to right):
Power Jack
Important: If desktop power is used to power the Receiver, only the provided desktop power supply should
be used and it must not be altered in any way. Remote power can also be provided via a switcher, PDXL-2
(FG1090-170), or PS-POE-AT-TC (FG423-84).
The power receptacle is a 2.1 mm DC jack for connecting power. Power can come from a locally connected DC
supply of 12 V. An automatically adjusting universal 110/220 IEC power supply is provided. The power supply is
ENERGY STAR
Note: The HDMI RX can also be powered through the DXLink connector when it is attached to a DXLink
Output Board in an Enova DGX Switcher. We recommend calculating the power budget for the switcher to
maintain the redundancy of its power supplies (see page 41).
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Normal Display
Green Power is applied to the Receiver
Green A video signal is present through the Receiver
Green An embedded audio signal is present through the Receiver
The Receiver is in one of the three modes for scaling
One LED is green • At initial power up, the Receiver defaults to the Auto scaling option*
The other two are off
• Pressing the Scaling button cycles the module through the options:
• If Bypass is solid and Auto is flashing, then the RX is trying to read EDID
Red IR TX active communication
Yellow IR RX active communication
Red Serial TX active communication
Yellow Serial RX active communication
Green Active LAN connection to an AMX Network (Blinking = #3 Toggle OFF)
Green LAN connection is active
OFF CEC is not currently supported
Yellow USB port connection is established (for details, see page 27)
DXLink input connector
ICS LAN 10/100 connector
®
qualified to ensure maximum efficiency and savings.
Indicates
Bypass, Auto, and Manual
from the sink
USB port
RS-232 port
IR ports
Product Overview and Specifications
Stereo Audio Out connector
HDMI Out connector
23