Factory Default Parameters - AMX DXLink Multi-Format Wallplate Instruction Manual

Factory Default Parameters

Factory Default Parameters
Parameter
MAC Address
Serial Number
Ethernet Mode
IP Addressing Mode
IP Address (for static mode)
Netmask (for static mode)
Gateway (for static mode)
DNS1 (for static mode)
DNS2 (for static mode)
DNS3 (for static mode)
DNS Domain
Hostname
Master Connection Mode
Master URL
(for TCP and UDP URL modes)
Master Connection Port Number
(for TCP and UDP URL modes)
Friendly-Name
Location
Stored MAC Address of Master
(for NDP binding)
ICSP Device Number
System Number
Telnet Port
SET BAUD
CTOF Time
CTON Time
Receivers Only
VIDOUT_ASPECT_RATIO
VIDOUT_RES_REF
AUDOUT_FORMAT
Transmitters Only
VIDIN_AUTO_SELECT
VIDIN_FORMAT
VIDIN_RES_AUTO
VIDIN_RES_REF
VIDIN_PREF_EDID
VIDIN_EDID
VIDIN_HDCP
VIDIN_VSHIFT
VIDIN_HSHIFT
VIDIN_PHASE
AUDIN_FORMAT_AUTO
AUDIN_FORMAT
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Value
As set in Factory
As set in Factory
Auto (i.e., speed, duplex, both, auto)
DHCP
192.168.1.2
255.255.255.0
192.168.1.1
192.168.1.1
192.168.1.1
192.168.1.1
amx.com
Last 7 digits of the serial number
NDP - For details, see page 116.
"" (blank)
1319
"" (blank)
Note: If the Friendly Name is non-blank, both Friendly Name and Location are
concatenated to make NDPSTRING2, otherwise NDPSTRING2 is generated
from the unit's serial number.
"" (blank)
00:00:00:00:00:00
0 (0 = receive dynamic device number from Master)
0
23
A value of 0 disables the Telnet server. Telnet is enabled by default.
9600, N, 8, 1
5 (0.5 seconds)
5 (0.5 seconds)
STRETCH
1280x1024,60 (for Manual Mode)
All
ENABLE
HDMI (on Port 7), VGA (on Port 8)
ENABLE
1280x1024,60
1920x1080p,60
MIRROR OUT 1 (on Port 7), ALL RESOLUTIONS (on Port 8)
ENABLE
0
0
0
ENABLE
Analog
Network Configuration
66