Table of Contents
Advertisement
INTERLOCK SYSTEM
Beacon fires are fitted with an "interlock" system.
A situation where the fire door is closed and the ash
door is open may lead to serious over firing which
could damage the appliance. Correct use of the
doors and interlock system will ensure that this
does not happen.
Operation is as follows:
A pivoted lug prevents closure of the fire door,
unless the ash door has been shut first. When the
fire door is shut the ash door knob can be turned
anti-clockwise by up to 95 degrees creating a
variable gap between the top of the ash door and the
body, through which primary combustion air can
enter the appliance.
Note: In order to turn the ash door knob
sufficiently for the catch to release and permit the
ash door to be opened fully THE FIRE DOOR
MUST BE OPENED FIRST.
MULTI - PURPOSE OPERATING
TOOL
Your Aarrow fire comes with a multi-purpose tool,
which is used to empty the ash pan. (fig. 4) Please
ensure the forked end of the tool is located fully
into the ashpan before removal.
DOOR TRIM
Beacon fire doors are fitted with a brushed steel
finish trim as standard. This, clips on to the small
lugs at the top and bottom of the aperture in the cast
iron fire door, as a "spring fit". When fitted, the trim
Beacon Multifuel Stoves
Fig. 4
OPERATING INSTRUCTIONS
locks the glass retaining clips in position.
(Fig 5)
The fire door should be removed so that the above
operations can be carried out on a workbench or
similar. Remove the door by GENTLY tapping the
door upwards; this will lift off of its hinges.
FIRE DOOR GLASS
If necessary the glass can be removed as follows
see Fig. 6.
Step 1 Remove the brushed steel finish trim by
pressing on the curved edge at the top until the trim
can be disengaged from the lugs.
Step 2 Slide the two glass retainer clips on one side
only, inwards, towards the centre of the door as far
as they will go.
Step 3 Pull this side of the glass away from the door
casting, easing the tags on the glass retaining clips
past the edge of the aperture in the door casting.
Step 4 Remove the glass completely. Store glass-
retaining clips and white gasket (if sound) safely
for re-use.
Step 5 Follow this procedure in reverse to fit
replacement door glass or gasket.
Fig. 5
9
Advertisement
Table of Contents
