Valet Mode (Via Remote); 2-Way Remote Control (If Equipped) - Fortin FSA-206 User Manual

VALET MODE (VIA REMOTE)

Valet Mode disables the remote-starter and alarm. Whenever the vehicle is being serviced
or repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to
prevent an accidental Remote-Start.
Note: The alarm system is deactivated (including Starter Kill) when the system is in Valet
Mode. However you are still able to lock & unlock the doors, and release the rear
hatch/trunk. This method of enabling/disabling Valet Mode uses the remote transmitter
instead of the valet switch indicated in the preceding section.
To enter Valet Mode using the remote transmitter proceed with the following steps:
STEP 1
Simultaneously press the
second. The parking lights will flash once.
STEP 2
The LED will turn ON solid and remain ON.
To exit Valet Mode using the remote transmitter proceed with the following
steps:
STEP 1
Simultaneously press the
second. The parking lights will flash once.
STEP 2
The LED will turn OFF or will start to flash.

2-WAY REMOTE CONTROL (IF EQUIPPED)

The 2-way remote control is
built with the latest RF
telecommunication
technology. It is functional up
to 4000 feet (range may
vary depending on
environment). The remote
control has a multi-color
LED and a speaker to
provide both a visual and
audible confirmation of the
status of your vehicle.
(LOCK) and
(LOCK) and
User guide
(UNLOCK) buttons for 1
(UNLOCK) buttons for 1
8