Vehicle Status Query; Cold Start Timer Mode; Auxiliary Use (5 Button Transmitter Only) - Fortin FSA-206 User Manual

VEHICLE STATUS QUERY

The status of the remote-starters or alarm system can be queried via remote
control with the following procedure:
STEP 1
STEP 2
STEP 3
LED
1 Green flash
2 Green flashes
Flashes Red for 20
seconds
1 Green flash
NOTE: It is possible to program the module to prolong the life of the remote control
batteries. When this feature is enabled the module does not transmit an alarm status to
the remote control when the alarm is triggered. Ask the installer or sales representative
for more details.

COLD START TIMER MODE

Cold Start Timer Mode will activate the Remote-Starter every 1.5 or 3 hours and will run
for 4 minutes (9 to 20 minutes for diesel engines). The Remote-Starter will repeat this
sequence for up to a maximum of 24 hours. For manual transmission vehicle's Ready
Mode must be enabled for this to work, and if at any time Ready Mode is disable the
sequence will be cancelled.
To enable Cold Start Timer Mode proceed with the following steps.
Simultaneously Press
second until the parking light flash once.
To disable Cold Start Timer Mode do any of the following:
• Simultaneously Press Unlock and Start buttons for 1 second until the parking light flash
twice.
• Put the Remote-Starter/alarm into Valet Mode.
• Remote-Start the vehicle.
• Open the hood.
• Press the brake pedal.
• Turn the key to the ignition (ON / RUN) position.
• Disable Ready Mode (manual transmission).
Note: If the Alarm is triggered during Remote-Start (Cold Start), the vehicle will stop
running, but Cold Start will not cancel it's schedule.

AUXILIARY USE (5 BUTTON TRANSMITTER ONLY)

Aux 1 : Drivers side sliding door (if installed) :
Press the button AUX button (the remote light flash slowly) you
have 12 seconds to press the button
light flashes rapidly). Repeat this sequence to close the driver
side sliding door.
Press the AUX button for one second and
AUX X1
release.
The LED will start flashing Blue.
Press the AUX button for one more
AUX X1
second and release.
VEHICLE STATUS
SPEAKER
1beep
2 beeps
Oscillating tone
Ascending tone
(Unlock) and
User guide
STATUS (IF EQUIPPED)
The vehicle is LOCKed (and ARMed)
The vehicle is UNLOCKed (and DISARMed)
An alarm has been triggered on the vehicle (if
equipped)
The vehicle is running by remote-start.
(Start) buttons for 1
(Lock) (the remote
10