Valet Coding Disabled (Default); Valet Mode (Via Remote) - Fortin RM442 User Manual

VALET CODING DISABLED (DEFAULT)

To activate and deactivate Valet Mode using the valet switch proceed with the following steps :
STEP 1
STEP 2
3X
STEP 3

VALET MODE (VIA REMOTE)

Valet Mode disables the remote-starter and alarm. Whenever the vehicle is being serviced or
repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to prevent an
accidental Remote-Start.
Note : The alarm system is deactivated (including Starter Kill) when the system is in Valet Mode.
However you are still able to lock & unlock the doors, and release the rear hatch/trunk. This method
of enabling/disabling Valet Mode uses the remote transmitter instead of the valet switch indicated
in the preceding section.
To enter Valet Mode using the remote transmitter proceed with the following steps :
STEP 1
STEP 2
To exit Valet Mode using the remote transmitter proceed with the following steps :
STEP 1
STEP 2
Insert the key and turn it to the ignition (ON/RUN) position. The
vehicle does not need to be started.
Within 10 seconds press and release the button on the antenna
3 times.
Valet mode enabled : The LED is ON
Valet mode disabled : The LED is OFF
Press and release the FUNCTION button, within 12 sec-
onds simultaneously press and hold the LOCK and UN-
LOCK buttons for 1 second. The remote's Green LED will
fl ash and beep once to confi rm. The parking lights will fl ash
once.
The LED will turn ON solid and remain ON.
Press and release the FUNCTION button, within 12 sec-
onds simultaneously press and hold the LOCK and UN-
LOCK buttons for 1 second. The remote's Green LED will
fl ash and beep once to confi rm. The parking lights will fl ash
once.
The LED will turn OFF or will start to fl ash.
Page 14 / 21