Battery Charger Modules; Safety Warnings - Avaya RS9 Installation And Operator's Manual

Introduction

Battery Charger Modules

NOTE One battery charger module is required whenever one or two EBCs are used.
A 9 kVA UPS system with 13 or 14 battery strings also requires one battery charger
module.
The optional battery charger module is designed to provide additional
current for faster recharging of UPS battery modules in systems with
many batteries. It is capable of providing up to 20 amperes of current for
optimum charging, based upon the condition and number of batteries in
the system.
The battery charger module is similar in appearance to a power module.
The primary difference is the light-purple colored front label. It can be
plugged into any UPS cabinet slot above the battery modules.
The battery charger module operates in automatic modes within the UPS
cabinet under control of the UPS power modules. It communicates
through a controller area network (CAN) bus with the power modules.
The power modules monitor and control the battery charger. Alarm
conditions detected by the battery charger module are logged and
announced by the UPS system (see "Alarm Log" on page 38). Normal
output voltage is 133 Vdc.

Safety Warnings

Read the following precautions before you install the UPS.
SAVE THESE INSTRUCTIONS. This manual contains important instructions that you
should follow during installation and maintenance of the UPS and batteries. Please
read all instructions before operating the equipment and save this manual for future
reference.
S
A maximum of seven power and/or battery charger modules can be installed in the
system.
S
Battery modules used in the Avaya RS9 system weigh 30 lb (14 kg). Use care in
lifting and moving battery modules.
2
Avayat RS9 UPS (9–18 kVA, 9-Slot Models) Site Preparation, Installation and Operator's Manual
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
C A U T I O N
S
164201543 Rev A