Guitar Tab - TC-Helicon VoiceLive 3 Reference Manual

Guitar tab

Input Gain parameter
Use the Input Gain parameter to adjust the input
level for the Guitar IN. To set this correctly, do
the following:
– Plug in your guitar.
– Turn your guitar's volume control to maximum.
– Play the loudest you normally would.
– Turn the Input Gain parameter up until only the
green and yellow LEDs of the Level indicator
light up.
– If you see the red LED light, turn Input Gain
down until the red LED no longer lights.
This is your optimal Input Gain setting.
VoiceLive 3 – Reference manual (2014-03-29)
Phase parameter
Use the Phase parameter to invert the phase of
the guitar signal.
Parameter settings:
Normal:
– Signal phase is maintained as it is at
the guitar input.
– Inverted: Incoming signal phase is reversed.
It can sometimes be beneficial to invert the
phase of a guitar to prevent feedback from
stage monitors. This is especially applicable
to acoustic guitars
Speaker Sim Enable parameter
Use the Speaker Sim Enable parameter to switch
the speaker simulation portion of the guitar Amp
effect block on or off.
Parameter settings:
– On: Speaker simulations are active. This is a
good setting for use with a PA or FRFR (Full
Range, Flat Response) speaker.
– Off: Speaker simulations are turned off. This is
a good global setting if you are plugging into a
nice amplifier and want to maintain its "sound"
relative to the guitar effects.
Setup
96