TC-Helicon VoiceLive 3 Reference Manual page 15

4. Home button
Use the Home button to return
to the "top level" interface. The
screen will show Preset Num-
ber and any effects associated
with the current layer.
5. Control knob
Use the Control knob to move
through Presets and scrolls up/
down when in an edit screen.
When in the "Home" screen,
press to add or remove the
current Preset from the Favor-
ite genre.
6. Vocal button
Use the Vocal button to enter
the Vocal edit screens. This is
where you can make changes
to the vocal effects for the cur-
rent Preset. For more informa-
tion, see "Editing the Vocal layer".
7. Guitar button
Use the Guitar button to en-
ter Guitar edit screens. This is
where you can make changes
to any of the guitar effects for
the current Preset. For more in-
formation, see "Editing the Guitar layer".
VoiceLive 3 – Reference manual (2014-03-29)
8. Looper button
Use the Looper button to enter
the Loop options screen. Here
you can control several general
Loop options.
9. Mix knobs
From the Home screen, turn-
ing any mix knob enters the
Mix screens (Main, Head-
phones and Effects).
Within an Edit page, the mix knobs adjust values
and settings.
10. Arrow buttons
When you are on the Home
screen, you can use the Ar-
row buttons to move through
Presets.
When you are on an Edit screen, use the Arrow
buttons to move between pages.
11. NP LED
The NP LED lights when Nat-
uralPlay (chord) information is
received via Guitar, MIDI, Aux
or RoomSense.
12. Level LEDs
The Level LEDs show input lev-
el for the Mic input. The red
LED also lights if any other in-
put – for example your guitar –
clips (too much signal).
Introduction
13