Rack Mounting; Turning The Power On - JVC RM-HP250DE Instructions Manual

Rack Mounting

Mount this unit to the EIA rack.
Rack mount bracket
2

Turning the Power ON

REMOTE CONTROL UNIT RM-HP250
WHITE MASTER BLACK
PAINT AUTO
P W.BAL
B
MID A
AUTO
R B MANU
PRESET
NOTE
When an item is controllable from both the RM-HP250 and the camera, the control from the camera is defeated. Functions not
available on the camera cannot be controlled from this unit.
When connecting the RM-HP250 to the camera, do not connect a local remote controller to the camera.
After turning the RM-HP250 OFF, wait at least 10 secends before turning it ON again.
2
1
(x4)
POWER
IRIS
I
O
CLOSE OPEN
POWER switch
1.
Remove the screws 1 on the four stands at
the bottom
Remove the stands.
2.
Mount the unit to the rack using the screws 2
Secure to the rack with the optional screws (x4) (M5 x 10
mm).
NOTE
If the RM-HP250 is rack-mounted, be sure to insert
ventilated panels above and below it in order to improve
ventilation. Do not stack two RM-HP250 units or place
any object on top of a RM-HP250 unit.
In addition, make sure to keep surrounding temperature
of this unit below 40°C during use.
1.
Connect the camera to the RM-HP250 using a proper con-
nection method.
2.
Press the POWER switch of the RM-HP250 to ON.
Connection
11