Operating The Laser; Maintenance; Ordering Replacement Parts - Power Craft PMS 210/1 User Manual & Warranty

Anleitung_PMS_210-1_SPK7:_
Take the blade (5) off the inner flange and pull
out downwards.
Mount the new saw blade in reverse order and
fasten.
Important! The cutting bevel of the teeth, i.e. the
direction of rotation of the saw blade, has to
conform with the direction of the arrow marked on
the housing.
Clean the saw blade flanges thoroughly before
mounting the saw blade.
Reattach the movable blade guard (6) in reverse
order.
Before using the saw again, check that the safety
devices are in good working order.
Important: Every time that you change the saw
blade, check to see that it spins freely in the
groove of the turntable in both perpendicular and
45° angle settings
8. Operating the laser (Fig. 12/13)
To switch on:
Move the ON/OFF switch (1) to the "I" position.
A laser line is projected onto the material you wish to
process, providing an exact cutting line.
To switch off:
Move the ON/OFF switch to the "0" position.
Replacing the battery:
To replace the battery, proceed as shown in Fig. 14.
Observe plus and minus signs in accordance with the
battery and appliance; replace a whole set of
batteries at once; remove batteries from appliance if
it will not be used for some time; never dispose of
batteries in fire, never attempt to recharge batteries,
keep away from children.

9. Maintenance

Keep the machineʼs air vents unclogged and
clean at all times.
Remove dust and dirt regularly from the machine.
Cleaning is best done with compressed air or a
rag.
Re-lubricate all moving parts at regular intervals.
Never use caustic agents to clean plastic parts.
Helpline No. UK / Northern Ireland 0151 649 1500 Rep. Ireland 189 094 6244
Model Number: PMS 210/1
11.06.2007 14:45 Uhr Seite 12

10. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Model number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
12