Power Craft PMS 210/1 User Manual & Warranty page 11

Anleitung_PMS_210-1_SPK7:_
Conversions, adjustments, measurements and
cleaning jobs are to be performed only when the
motor is switched off. Pull out the power plug!
Before you switch on the machine, check that all
wrenches and adjustment tools have been
removed.
When you leave your workplace, switch off the
motor and pull out the power plug.
Electric installation work, repairs and
maintenance are to be carried out only by
specialists.
All guards and safety devices have to be refitted
immediately after completion of any repairs or
maintenance.
It is imperative to observe the manufacturerʼs
safety, operating and maintenance instructions
as well as the dimensions quoted in the technical
data.
It is imperative to observe the accident
prevention regulations in force in your area as
well as all other generally recognized rules of
safety.
Note the information published by your profes-
sional associations.(VBG7j)
Switch on the dust extraction system each time
you use the machine.
The machine may be used in closed rooms only
in conjunction with a suitable vacuum extraction
system.
The saw must be connected to a 230 V socket
outlet with a minimum 10 A fuse.
Never use light-duty machines for heavy-duty
work.
Never use the cable for any purpose other than
that for which it is intended!
Adopt a firm standing position and keep your
balance at all times.
Check the tool for signs of damage!
Before you carry on using the tool it is imperative
to check that its safety devices and any slightly
damaged parts are working properly and in the
way intended.
Check that the moving parts work properly and
do not jam. Check if any of the parts are
damaged. All parts must be fitted correctly and
satisfy all conditions for the tool to work properly.
Unless otherwise stated in these instructions
damaged safety devices and parts must only be
replaced by experts approved by the
manufacturer.
Repairs are only to be carried out by qualified
electricians authorised by the manufacturer using
original replacement parts.
Be careful when making vertical cuts.
Helpline No. UK / Northern Ireland 0151 649 1500 Rep. Ireland 189 094 6244
Model Number: PMS 210/1
11.06.2007 14:45 Uhr Seite 9
Take special care when making double mitre
cuts.
Do not overload the machine!
Recommended Personal Protective Equipment
Wear safety goggles.
Use a dust mask on dusty jobs.
Wear ear protection.
Wear gloves.
Check the machineʼs power cable / extension
cable for damage.
Noise emission values
The sawʼs noise is measured in accordance with
DIN EN ISO 3744; 11/95, E Din EN 31201; 6/93,
ISO 7960 Annex A; 2/95. The machine may
exceed 85 dB(A) at the workplace. In this case,
noise protection measures need to be introduced
for the user (ear-protection).
Sound pressure level L
Sound power level L
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
at the workplace include the duration of impact, the
type of room, and other sources of noise etc., e.g.
the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved."
Wear goggles
Wear ear protection
Wear a dust mask
Wear gloves
Cutting
104,4 dB(A)
pA
111,4 dB(A) 107,2 dB(A)
WA
Idling
94,2 dB(A)
09