Connecting The Sender Local Outputs; Connecting The Sender To The Receiver - Hall Research Technologies U97-ULTRA User Manual

Model U97-ULTRA
If a serial communication is needed, connect a PC's serial port to RS232, a DB9 female
connector. Usually a straight-thru DB9 M/F cable is required (not supplied).
Use the included USB cables to connect the PC to USB STD and DR1 connectors.
These are Type 'B' connectors, which are used to attach the USB cable to a USB device.
The opposite end of the USB cable uses Type 'A' connectors which connects a USB
device to a PC or a USB hub. The figure below shows two different types of USB
connector.
USB Port & Connector Types

2.2 Connecting the Sender local outputs

The sender has buffered outputs for connection of two LCD's, a passive speaker, and
two USB devices (commonly keyboard and mouse or a KVM Switch).
Sender Local Output Connections

2.3 Connecting the Sender to the Receiver

Depending on the specific need you need from 2 to 4 UTP cables to connect the sender
to the receiver, please refer to table on page 6.
12