Receiver Cover - Hall Research Technologies U97-ULTRA User Manual

Model U97-ULTRA

4. Receiver Cover

In the diagram below the location of holes where the cover screws to the receiver are
shown with little arrows. All screws
are provided with the unit. There are
4 screws on the top and 2 on the
bottom (not shown).
You can use the slotted holes at
either end of the unit to zip-tie the
cables in place.
Once the cover is firmly attached and
Locations of attachment holes for screws
cables zip-tied in place, you can screw
the entire assembly to a suitable base
using the L flanges on either side of
the unit.
Make sure that the front panel is accessible for skew and or video adjustments as
needed.
Cables can enter and leave from either end
18