Table of Contents
Advertisement
Quick Links
User's Manual
UH-1D
HDMI over Single Cat6 Extender kit
Extends uncompressed Full-HD (1080p) to 130 ft (40m)
Provides local HDMI loop-output on the transmitter
EDID learn button to store and emulate EDID from any display
3.5mm analog and RCA digital audio outputs
Extends IR in both directions
UMA1231 Rev n/c
© Copyright 2015. Hall Research, Inc. All rights reserved.
1163 Warner Ave Tustin, CA 92780, Ph: (714)641-6607, Fax (714)641-6698
Advertisement
Table of Contents
Related Manuals for Hall Research Technologies UH-1D
Summary of Contents for Hall Research Technologies UH-1D
- Page 1 User’s Manual UH-1D HDMI over Single Cat6 Extender kit Extends uncompressed Full-HD (1080p) to 130 ft (40m) Provides local HDMI loop-output on the transmitter EDID learn button to store and emulate EDID from any display 3.5mm analog and RCA digital audio outputs...
-
Page 2: Table Of Contents
HDMI over Single Cat6 Extender kit Table of Contents 1.0 Introduction ........................3 2.0 Features ..........................3 3.0 Installation .......................... 4 2.1 Package Contents ..................3 3.1 Sender Connections .................. 4 3.2 Receiver Connections ................4 4.0 Operation ..........................6 3.3 IR Remote Extension ................ -
Page 3: Introduction
(SPDIF) as well as analog (stereo L/R) outputs for connection to audio equipment. The UH-1D allows connection of an IR detector and an IR emitter cable to each end. This provides the ability to extend IR signals in either direction. For example, when an IR detector is connected to the remote Receiver and IR emitter is connected to the sender, the user, from the remote TV end, can control the source using an IR remote. -
Page 4: Installation
HDMI over Single Cat6 Extender kit Use only regulated 5v DC supply (center positive) as supplied with the unit. 3.0 Installation The following diagram illustrates a typical setup. Note that the IR cables are optional and should be ordered separately. Installation diagram showing all possible connections 3.1 Sender Connections The input side of the sender unit is shown below. -
Page 5: Ir Remote Extension
3.3 IR Remote Extension The UH-1D allows connection of an IR detector and an IR emitter cable to each end. This provides the ability to extend IR signals in either direction. For example, when an IR detector is connected to the remote Receiver and IR emitter is connected to the sender, the user from the remote TV end can control the source using an IR remote. -
Page 6: Operation
By default, the LEARN EDID light is off. This means that the unit is using a generic default internal EDID for the source that includes various PC and TV resolutions that the UH-1D can support. If your specific TV does not support some of the resolutions that the default EDID reports to the source, you can "learn"... -
Page 7: Specifications
UH-1D 5.0 Specifications Video Standards DVI (single link) and HDMI (compliant with HDMI 1.4 video specifications including 12 bit color depth and 3D video - 4K video is not supported) Signal type TMDS Connectors Locking HDMI Video Resolutions For DVI signal... - Page 8 © Copyright 2015. Hall Research, Inc. All rights reserved. 1163 Warner Ave., Tustin, CA 92780 Ph: (714)641-6607...