Installation; Sender Connections; Receiver Connections - Hall Research Technologies UH-1D User Manual

HDMI over Single Cat6 Extender kit

3.0 Installation

The following diagram illustrates a typical setup. Note that the IR cables are optional
and should be ordered separately.
Installation diagram showing all possible connections

3.1 Sender Connections

The input side of the sender unit is shown below. Connect the video source to the
connector labeled HDMI IN. Optionally connect a local TV or another Sender unit to
the connector labeled HDMI OUT.
Connect a Category 5e/6 cable to the opposite end's RJ45 connector and plug in the
included power supply.

3.2 Receiver Connections

The output side of the receiver unit is shown below. Connect the video source to the
connector labeled HDMI OUT. Optionally connect any audio device to the analog or
digital audio outputs.
4
Use only regulated 5v DC supply (center
positive) as supplied with the unit.
Video input and output on the Sender