Turning Handset On/Off - Geemarc AMPLIDECT 280 Manual

TAM Functions
(AMPLIDECT285™ only)
Announcement
(AMPLIDECT285™ only)
It is necessary to record the announcement which
requests the caller to leave a message when
nobody is at home. The answer and record
message (Announce1) and the answer only
message (Announce2) can be up to 3 minutes
respectively.
Record Announce1
Auto-answer Announce1 is a conventional
message requesting you to leave a message. If
you have not recorded a personal Announce1, the
unit will play the default one "Hello, your call
cannot be taken at the moment, to record
your message, please speak after the tone".
If you want to change Announce1, do the
following steps to update it:
1. Press the TAM soft key in Standby mode.
46
2. Press the Select soft key to choose Announce.
3. Press Select key again to choose Announce1.
4. Press the key repeatedly to choose
Record, press the Select soft key.
5. You can record your announcement after a
tone. Recording will stop automatically after 3
minutes. You can also confirm and end the
recording by pressing the OK key. During
recording the LCD shows "Recording...".

Turning Handset On/Off

If the handset is in power off mode, when you
p l a c e t h e h a n d s e t o n t h e b a s e ,
automatically turns on. To turn the handset on
or off in Standby mode, follow these steps:
1. To turn on the handset when it's off, press
and hold the key until you switch the
display on. On power up, the handset will
enter subscription mode and search for a
registered base. A message as shown
below will be displayed to the user, and the
signal icon will flash.
Searching...
Note:
i t
If the handset is successful in finding a
base, the handset will enter the Standby
mode, the display will show
number and the handset name (if you
have one saved as described on page 24),
signal icon, battery icon and current time.
If the handset is not successful in finding a
base, the handset will behave according to
the Out Of Range condition.
2. To turn the handset off, keep the
pressed until the display turns off.
Note:
Nothing will appear on the LCD when battery
power is very low. YOU SHOULD FULLY
CHARGE THE HANDSET BEFORE USING.
handset
key
15