Wall Mounting - Geemarc AMPLIDECT 280 Manual

Wall mounting

Place the plate for wall mounting under the telephone.
Drill 2 holes in the wall 60 mm apart, insert the wall
plugs and the wall mounting screw. The screws should
protrude 6-7 mm. Fit the base onto the screw-heads
and slide down to secure.
14
Mounting
Pins
Piece of wall
mounting
Record Announce2
Announce-only Announce2 is an answer-only
message. If you have not recorded a personal
Announce2, the unit will play the default one
"Hello, your call cannot be taken at the
moment, please call back later".
If you want to change Announce2, do the
following steps to update it:
1. Press the TAM soft key in Standby mode.
2. Press the Select soft key to
Announce.
3. Press key repeatedly to choose
Announce2, then press the Select key to
confirm.
4. Press the key repeatedly to choose
Record, press the Select soft key.
5. You can record your message after a tone.
Recording will stop automatically after 3
minutes. You can also confirm and end the
recording by pressing the OK key. During
recording the LCD shows "Recording...".
Use the base to record Announce1
/Announce2
Press and hold the or key on the base unit
until the system announce. Begin speaking after
you hear the beep. Use the key to finish at any
time.
Notes:
When recording the announcement, speak
towards the microphone on the base. In
choose order to achieve the best recording results
please make sure you are about 20cm from
the microphone.
If you record/playback/restore Announce1 or
Announce2, the answer mode (refer to part.
Answer mode Select) will be switched to
the corresponding mode automatically.
47