Paging; Dial Mode - Geemarc AMPLIDECT 280 Manual

One-Touch Memories
You can store up to 4 numbers in direct memory.
All the number will be stored in phone book.
Storing Memory Numbers
1. Press the memory key (M1 to M4) in Standby
mode.
2. The display shows "Number ?". Enter the
desired number (up to 20 digits), press the
Next soft key.
3. Use the key to select the ring you like to
associate with the number, press the Save soft
key to confirm.
Viewing Memory Numbers
1. In the Standby mode, press the Down key.
2. Press the key repeatedly until the desired
number is displayed.
34
Dialing from One-touch Memories
In the Standby mode, press M1 to M4 button to
dial out the corresponding number.
Editing Memory Numbers
Perform the steps of the "Editing the Phone book
Entries" paragraph.
Note:
The memory default names are M1: to M4:,
you can add something behind them but
cannot delete the default name. e.g. you can
modify M1 as M1: home.
Deleting Memory Numbers
Perform the steps of the "Deleting the Phone book
Entries" paragraph.

Paging

You can page the handset from the base unit.
The handset will ring ring with a special tone.
This is useful to locate a lost handset.
Press the key on the base unit (less than 5
seconds), all the handsets registered to the
base will ring for about 60 seconds.

Dial Mode

You can change the dial mode using the
following steps:
1. Press the Menu soft key.
2. Press the key repeatedly to choose BS
Settings, and press the Select soft key.
3. Use the key to choose Dial Mode, then
press the Select soft key.
To stop paging, press the key on the base again
or any key on the handset.
Note:
On a long key press, more than or equal to
5 seconds, the base will enter subscription
mode. For details, see page 38.
4. You can press the key to select the required
dial mode options (Tone/Pulse) and press the
Save soft key. A confirm beep will be heard.
Note:
If you are not sure which dialing mode to
select, please contact your local
provider.
service
27