Removing The Top - Whirlpool MVWC400XW Technical Education

Access to the detergent dispenser and lid
switch/latch assembly is from under the top.
The top his held on with by channel connec-
tions at the front and two screws at the rear.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. a. Turn off the water supply to the washer.
b. Tape the lid down.
3. a. Remove top screw from each hinge
(2), see figure 1.
b. Remove wire harness cover.
4. Slide top forward about ½ ",
Remove these Screws
Figure 1
see figure 2.
5. Raise the top about ¼ ".
1/2"
Figure 2

REMOVING THE TOP

Wire harness cover
4-6
6. While still keeping it lifted, push the top
back about ¼ ", see figure 3.
7. Tilt the top up on the rear hinges,
1/4"
Figure 3
see figure 4.
Figure 4