Removing The Detergent Dispenser Assembly - Whirlpool MVWC400XW Technical Education

REMOVING THE DETERGENT DISPENSER ASSEMBLY

The detergent dispenser assembly fits into
the top.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the water inlet valves, see
figure 1 and the section: "REMOVING
THE WATER INLET VALVE".
Figure 1
4. Raise the top on the hinges, see figure 2
and the section: "REMOVING THE
TOP".
5. Remove the dispenser drawer,
see figure 2.
6. Remove the (2) screws securing the
dispenser to the front trim, see figure 3.
Remove Screws From
Behind Dispenser
7. Remove the trim, see figure 4.
8. The dispenser is held in the back by
tabs, see figure 5.
4-8
Remove Dispenser Drawer
Figure 2
Figure 3
Figure 4
Tabs
Figure 5