Advertisement
6.11 6HUYLFH )XQFWLRQV 0DQXIDFWXUH
:KHQ FDOOLQJ VHUYLFH IXQFWLRQV JHQHUDOO\ QR ULQVLQJ SURJUDP PD\ EH VHOHFWHG
&DOOLQJ WKH 0DQXIDFWXUH7HVWLQJ 3URJUDP
l
(see description page B 12)
Not for the use of final customers
w Press both program keys S1 and S3 simultaneously and keep them pressed
until the machine has been switched on by use of the ON/OFF key S0.
w
As an acknowledgement that the function "Manufacture Test Program" is active, the key LED LD3 flashe
This LED will keep on flashing during the whole program cycle.
w
Program starts automatically after about 3 seconds.
w
The remaining program flow is identical to that of any Consumer rinsing program.
The usual rinsing program sequence is simulated.
w
In the manufacte test program, regeneration is always carried out independently of the demand
w
Program status is displayed by means of the PAA LED's LD9 through LD11.
w
In case of power failure, the test program is continued after approx. 3 seconds after the return of the pow
w
You can stop the test program by opening the door.
w
When the door is open, both the program key LED LD3 and the respective
PAA LED are lit.
w
You can exit from the test program by again pressing on the key S3.
(also see description on page B 5 "Clearing the program")
w
At the end of the manufacture test program, both the LED LD3 and the PAA LED "End" are lit.
6HWWLQJ DQG UHFRJQLWLRQ RI KHDWLQJ SRZHU
l
w
Heating capacity is included in machine model programming.
w
All machines of series EDW1000 are of standard design 10A only.
Advertisement
