Electrolux EDW 1001 Service Manual page 20

6.1 0RGLILFDWLRQV IURP (': WR (':
Author: Doris Reiß WPD/EP - Basis EDW1000 (C0901m10.s2)
1R *URVV 'HVFULSWLRQ RI WKH &KDQJH
1 Fan control
Program Reset during Drying in case of power failure
2
(switching ON/OFF)
Water hardness setting procedure changed.
3
Operation Manual needs to be adapted for existing machines.
Rinsing agent deconnectable
(Clip handle as for water hardness setting, but key 2)
4 for cleansing agent with integr. rinsing product. Rinsing agent
LED is deactivated.
Operation Manual needs to be adapted
Automatic half-charge detection
5
Limit and correcting factors in the EEPROM
Automatic Start for Super Simple
6
only when switching ON/OFF by use of main switch
Selection of two programs by one key only
7
Super Simple only (toggle function)
8 Superwash
9 Intensive program 80 min
10 Eat Load Run program
Point of rinsing with programs for new drying modified from
11
program start to Drying.
Wasserzulauf Trocknen wegen neuer Reg-dos
12
(New Water system)
New Reg-dos (New Water system) -
13
Change of rinsing to 2 litres in the EEPROM
With half-full detection - 5°C during Wash
14
not with Intensive)
15 New energy-saving program for BAB
Adaptation of minimum program durations for hot water
16
connection.
Intensive and normal programs without impulse rinsing for ZM
17
as well
5HPRYHG
18
Alternating spray beam drive by ball
5HPRYHG
19
Alternating spray beam drive by ball with half-full
5HPRYHG
20
Tablets option no longer possible
5HPRYHG
21
Subprograms no longer required were canceled.
5HPRYHG
22
Change of manufacture testing program for ZM
5HPRYHG
23
Program counter over the life cycle
'HWDLOHG 'HVFULSWLRQ
You should not make the user aware of filling up
rinsing agent, if this is already integrated in the
cleansing agent.
As with ET/ET plus by means of heating speed
You can define the program for automatic start in
the EEPROM
120 min
Only with ZM
Duration 30 min
1 l water admission for drying support
With half-full detection, the temp. is reduced by 5K
during Wash.
Readable in the EEPROM