Advertisement
6.6 ,QSXW 3KLORVRSK\ FOHDULQJ FKDQJLQJ FDQFHOOLQJ
&OHDULQJ D SURJUDPP
w
You can clear a rinsing program selected or already started at any time.
w
For this, press the key of the selected rinsing program until
the associated key LED goes dark (after approx. 2 secs).
©
During this time, the associated key LED and the LED's of any selected option keys are lit.
w
The rinsing program is canceled and cleared.
©
All LED's of all program and option keys, and also the PAA LED's will go dark, too.
©
Only the indicator lamp LD0 at the ON/OFF key remains lit.
w
The machine is now back in the prestart mode.
(see description page B 3 / "Switching ON the machine")
&KDQJLQJ WKH SURJUDP
w
Both "Clearing the program" and then "restarting" the desired program are possible (see above)
w
Direct change-over during operation is not possible.
,QWHUUXSWLQJ WKH SURJUDP 3DXVH )XQFWLRQ
w
You can interrupt the program for any period of time by use of the ON/OFF key S0 without any losses.
This is equal to a "Pause" Function. The same is true for any interruption by opening the door.
w
No clearing function is integreted into the ON/OFF key S0!
w
Whenever the program is interrupted with the ON/OFF key, all indications go dark.
w
After restarting by pressing the ON/OFF key or by opening the door, the program flow is continued
at once without need to press any button.
I Note:
w
All indications and acknowledgements appear in the same status as before the break
I
$WWHQWLRQ: This function is only applicable until the start of the program section "Drying".
w
From the program section "Drying" the following is true:
w
If the machine is stopped by pressing the ON/OFF key S0.
the program is cleared.
©
All displays go dark.
©
If you restart the machine by pressing the ON/OFF key S0, it will be automatically,
after closing the door, in "prestart" mode, so that you could immediately select a new program.
:KDW KDSSHQV ZKHQ RSHQLQJ DQG FORVLQJ WKH GRRU"
l
w
0DFKLQH LV VZLWFKHG 21 DQG LV LQ SUHVWDUW PRGH
w
After opening the door, all indications on the panel are maintained.
Full power supply to the electronic system is ensured as long as the machine remains switched ON.
w
7KH GRRU LV RSHQHG GXULQJ D SURJUDP LQ SURFHVV
w
By opening the door, you can interrupt the program without losses for any period of time.
This is equal to a "Break/Pause" function.
w
After opening, all displays on the panel are maintained so long as the machine remains
siwtched on by means of the ON/OFF key S0.
w
After closing the door, the machine immediately starts up, the program flow is continued.
ZKHQ WKH SURJUDP KDV DOUHDG\ VWDUWHG
With program sequences where the recycling pump is controlled, this one is operated
directly upon the startup for about 20 seconds at reduced speed. N
Advertisement
