Federal Communications Commission (Fcc) Notice; Fcc Rf Exposure Information - Fujitsu F-02F Instruction Manual

Federal Communications
Commission (FCC) Notice
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions :
a this device may not cause harmful interference, and
b this device must accept any interference received,
including interference that may cause undesired
operation.
Changes or modifications made in or to the radio phone, not
expressly approved by the manufacturer, will void the user's
authority to operate the equipment.
The device complies with 15.205 of the FCC Rules.

FCC RF Exposure Information

This model device meets the U.S. Government's requirements
for exposure to radio waves.
This model device contains a radio transmitter and receiver.
This model device is designed and manufactured not to
exceed the emission limits for exposure to radio frequency
(RF) energy as set by the FCC of the U.S. Government. These
limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The
guidelines are based on standards that were developed by
independent scientific organizations through periodic and
thorough evaluation of scientific studies.
The exposure standard for wireless tablet PC employs a unit of
measurement known as the Specific Absorption Rate (SAR).
The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are
conducted using standard operating positions as accepted by
the FCC with the device transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR
level of the device while operating can be well below the
maximum value. This is because the device is designed to
operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to
a wireless base station antenna, the lower the power output
level of the device.
177
Appendix/Index