IDEAL Evomax 30 Installation & Servicing Manual page 36

44 EVomAX uSER IntERfACE - ADVAnCED oPERAtInG InStRuCtIonS ContInuED....
DISAbLInG tHE AntI-LEGIonELLA funCtIon
Note that the Anti-Legionella Temperature Function is only
operational if a Domestic Hot Water Thermistor has been connected
Care should be taken in disabling this function as an unsafe condition
could result
Press SELECT and then hold + and - down together for more than
5s, the following screen will be displayed
Installer Mode
normal operation
Set Flow Temp'
Set DHW Temp'
Rotate the KNOB clockwise until the following screen is displayed
Installer Mode
Anti-Legion Temp'
Anti-Legion Enable
BUS Address
Flame/LPG Relay
Press SELECT and the following screen will be displayed
Anti-Legion Enable
on
Off
Press + and - to change to required setting then press ENTER to store
Rotate the KNOB clockwise until Normal Operation is highlighted again
and press SELECT to return to normal operation
36
InStALLAtIon
CHAnGInG tHE VoLt fREE buRnER on RELAy to oPERAtE
AS An LPG RELAy foR bELoW GRounD LEVEL LPG
APPLICAtIonS
If LPG is to be used in an application below ground level then an
additional valve is required to control the LPG input to the boiler
This valve should be wired from the Volt Free Burner on Relay and
enabled as follows
Press SELECT and then hold + and - down together for more than
5s, the following screen will be displayed
Installer Mode
normal operation
Set Flow Temp'
Set DHW Temp'
Rotate the KNOB clockwise until the following screen is displayed
Installer Mode
BUS Address
Flame/lPG Relay
Normal Operation
Press SELECT and the following screen will be displayed
Flame/LPG Relay
flame on
LPG Gas Valve
Press + and - to change to the required setting and then press
ENTER to store
Rotate the KNOB clockwise until Normal Operation is highlighted
again and press SELECT to return to normal operation
continued . . . . . . . .
EVOMAX -
Installation & Servicing