Winnebago Journey Owner's Manual page 97

Hide thumbs Also See for Journey:
Table of Contents

Advertisement

bin to the freezer, remember to lower the
shut-off arm (on). If the arm is up, the ice
maker will not operate.
Shut-Down of Ice Maker
To turn the ice maker off, simply raise the
shutoff arm (wire).
Winterizing the Ice Maker
When winterizing, make sure the water line
is completely drained by following this proce-
dure.
1. Drain coach water lines. See Sect. 10.
2. Unscrew the water supply line from the bot-
tom of the water inlet valve and drain any
water left in the line. This connection is
located in the refrigerator service compart-
ment on the outside of the coach. (See
Refrigerator Service Access Compartment
on the following page.)
Ice Maker Water Supply Connection
3. Let the ice maker run through a cycle, then
raise the shut-off arm.
4. Be sure water has drained from ice maker
supply line, then reconnect to inlet valve.
Start-Up (Removing from Storage)
1. Close all drain valves.
2. Turn the water supply on.
3. Be sure the ice bin is in place and the auto-
matic shutoff arm is down.
4. Let the refrigerator cool down to ice making
temperature. Remember, this can take up to
24 hours.
APPLIANCES & INTERIOR FEATURES
5. Let the ice maker cycle and dump the first
batch of ice.
Troubleshooting the Ice Maker
1. Is 110-Volt AC reaching the refrigerator?
A. Ice maker motor needs 110VAC to oper-
ate.
B. Be sure refrigerator power cord is
plugged in.
C. Check appropriate breaker on 110VAC
breaker panel.
2. Is 12-Volt DC reaching the refrigerator?
A. Refrigerator eyebrow control and power
supply board both need 12VDC to oper-
ate.
B. Check 12V fuse or breaker on converter
panel
3. Is water supply pressure at least 15 psi,
but no more than 125 psi?
A. If not enough, turn city water faucet open
further or check for blockage.
B. If too much, attach water pressure regula-
tor.
4. Is the water supply inlet valve on?
A. If not enough, turn city water faucet open
further or check for blockage.
B. If too much, attach water pressure regula-
tor.
5. Is the freezer compartment temperature
14° F or lower?
A. Turn refrigerator temperature control to
colder setting, if needed.
6. Is the ice maker's automatic shut-off arm
in the down (on) position?
A. If arm is not down, ice maker will not
operate.
7. Has it been at least 24 hours since the
refrigerator was turned on?
A. If not, allow more time.
B. If so, refer to Norcold refrigerator freezer
troubleshooting procedures in your dealer
service library.
8. Water not filling molds:
A. Water inlet valve off (on back side of
refrigerator).
B. Insufficient water pressure.
C. Water line blockage.
D. Faulty water solenoid - stuck off.
SECTION 8
8-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

2004 meridian itasca

Table of Contents