110-Volt Circuit Breakers - Winnebago Journey Owner's Manual

SECTION 6
ELECTRICAL SYSTEMS
AC input source from overloads. See the
Heart Interface operation information for
complete explanation and instructions on this
system.
Inverter Charger Unit Location
CAUTION
Do not store items too closely around
the inverter unit in the storage com-
partment. The inverter generates heat
while operating and needs unre-
stricted airflow for proper cooling.
12-Volt House Circuit Breakers
The 12-volt house breaker panel contains
pop-out breakers; push in to reset. The breakers
are clearly labeled for the circuits which they
protect. The breaker panel is located behind a
small door near the galley or below the refrigera-
tor.
6-4
House 12V Breakers
(below refrigerator)
*Typical view of breaker panel. Actual fuse or breaker
labels may vary according to appliance and equipment op-
tions. Fuses and breakers are labeled on panel.

110-VOLT CIRCUIT BREAKERS

The breaker panel protects all 110-volt com-
ponents in the motor home from either an over-
load on the circuit or a short in the wiring or
component itself. When an overload or short
developes, the breaker will open preventing any
further flow of electricity and, therefore, damage
to the system.
Shut off the equipment (example: air condi-
tioner) and allow a brief cooling period. Then
reset the breaker by moving the switch to "Off"
and back to "On". If the breaker continually trips
and no equipment is running, have the system
checked for a short in the wiring or the appli-
ances.
The 110-volt circuit breaker panel is located
behind the cabinet door under the bed.