Winnebago Journey Owner's Manual page 95

During operation in the AUTO mode, when
a higher priority power source becomes avail-
able, the operating controls will cease using the
current power source and will switch to the
higher priority power source. For example, if
AC electric becomes available while the refrig-
erator is operating in the AUTO LP GAS mode,
the refrigerator will switch to AUTO AC opera-
tion.
If an operating mode is not functional, a
diagnostic code will appear and the refrigerator
will attempt to operate in a lower power priority
source. If a lower power priority source is not
available, an alarm will sound and the refrigera-
tor will cease operation. Refer to the Diagnostic
Codes and Their Meaning for corrective actions.
Start-Up Instructions - Manual Mode
To operate in the MANUAL mode, press and
hold the MODE button until AUTO disappears
and the desired operating mode is displayed. If
the power source is interrupted while operating
in the MANUAL mode, a diagnostic code will
appear, an alarm will sound, and the refrigerator
will cease operation. For corrective actions, refer
to the Diagnostic Codes and Their Meaning on
page 10 of the Norcold Operator's Guide in the
blue binder.
AUTO and MANUAL Modes - Gas Opera-
tion Only
If the gas does not ignite within 30 seconds,
which may occur on initial start-up, the refriger-
ator's gas valve will automatically close and the
APPLIANCES & INTERIOR FEATURES
operating controls will select an alternate power
source (AUTO Mode) or MANUAL mode, will
revert to a stand-by mode in which an alarm will
sound and code A1 will be displayed in the cen-
ter window. The alarm and code will remain on
until the operating controls are turned OFF and
then ON again. If the gas does not ignite after
several attempts, check the input gas supply, or
consult with your dealer or a Norcold authorized
service center. A different mode of operation
may be selected by pressing and holding the
MODE button. The refrigerator will not switch
to the new operating mode until the MODE but-
ton is released.
Backup Operating System (BOS)
Your refrigerator features a Backup Operat-
ing System which keeps the refrigerator cool in
the event of a failure of the refrigerator's operat-
ing controls. If a failure occurs, the refrigerator
will display Diagnostic Code C5 and will switch
automatically to the BOS mode. This mode pro-
vides refrigeration until the refrigerator is ser-
viced. The fresh food and freezer compartment
temperatures should be monitored to prevent
over-freezing or thawing of refrigerator contents
when operating in the BOS mode. If the refriger-
ator temperature is too cold, adjust the thermo-
stat up (warmer) in one bar increments. If the
refrigerator temperature is too warm, adjust the
thermostat down (colder) in one bar increments.
Let the refrigerator operate at the new setting for
one hour before rechecking the freezer and fresh
food compartment temperatures. (Frequent door
opening prevents the temperatures from stabiliz-
ing.) Although the refrigerator can operate in
this mode, Norcold recommends that you seek
service to restore normal operation as soon as
practical.
Humidity - Storage Switch
Turning this switch to HIGH HUMIDITY will
keep the surface between the door openings dry
during high humidity conditions. The switch
should be left in the NORMAL OPERATION
position unless moisture collects around the door.
When storing your RV for the winter, place
this switch in the STORAGE (LIGHT OFF)
SECTION 8
8-3