Configuration (Standalone Mode); Manual Mode; Configuration (Dmx); Starting Address - Chauvet Hurricane Haze 3D User Manual

Configuration
(Standalone
Mode)

Manual Mode

Configuration
(DMX)
Starting
Address

DMX Channel Assignments and Values

2-CH

Page 12 of 16
Set this product in one of the standalone modes to control it without a DMX controller.
1. Connect this product to a suitable power outlet.
Turn this product on.
2.
Never connect a product that is operating in any standalone mode, such as
Manual mode, to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
To enable the Manual mode, follow the instructions below:
1. Press <MENU> repeatedly until h*** shows on the display.
2. Use <UP> or <DOWN> to adjust the haze volume.
3. Press <MENU> repeatedly until f*** shows on the display.
4. Use <UP> or <DOWN> to adjust the blower speed.
Set this product in DMX mode to control it with a DMX controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX
input socket of this product.
The Hurricane™ Haze 3D has one DMX personality, a 2-channel mode for basic
control.
The Hurricane™ Haze 3D uses up to two channels in its 2-channel DMX mode, which
defines the highest configurable address to 511.
When selecting a starting DMX address, always consider the number of DMX
channels the DMX mode uses. If you choose a starting address that is too high, you
could restrict the access to some of the product's channels.
If you are not familiar with the DMX protocol, download the DMX Primer from
www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <MENU> repeatedly until d*** shows on the display.
2. Use <UP> or <DOWN> to select the starting address.
Channel Function
1 Blower speed
2 Haze volume
Value Setting
000 ó 255
Low to high
000 ó 255
Low to high
Hurricane™ Haze 3D User Manual Rev. 1