Configuration (Standalone); Wireless Remote Control; Programmable Color Selection - Chauvet Geyser User Manual

Configuration
(Standalone)
Wireless Remote
Control
Programmable
Color Selection
Geyser™ RGB User Manual Rev. 6
Set the product to Automatic mode to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To trigger fog output and activate the color program using the wireless remote control, do
the following:
1. Plug the wireless receiver into the Remote Control Receiver port on the side of the
Geyser™ RGB.
2. On the wireless transmitter, press the button assigned to the color program (1–4).
The Geyser™ RGB emits fog and activates the color program for as long as you
hold down the button.
Note: If the color program is set to oFF for any trigger button, only fog output is
triggered when that button is pressed.
There is no need to set the DIP switches on the remote control's receiver. These
DIP switches are reserved for future use.
To select either the preset color program or one preset color to illuminate the fog using
the wireless remote control, follow the instructions below:
1. Press <MENU> repeatedly until CH-1–CH-4 shows on the display. Select CH-1,
CH-2, CH-3, or CH-4 to choose that color program.
Note: The color program numbers correspond with the numbered buttons on
the wireless transmitter.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select rAnd (for random colors) or Co 1–Co 9 (to choose
one of nine preset colors).
Note: Select oFF to turn off the color program for that button.
4. Press <ENTER>.
5. Repeat steps 1–4 to configure the other buttons.
Page 13 of 16