Table of Contents
Advertisement
O
PERATION
Color Zones
Color Zone 2
Configuration (DMX)
Use DMX configurations to operate the product with a DMX controller.
DMX Control
In this mode, each product will respond to a unique starting address from the DMX controller. All products
with the same starting address will respond in unison.
1.
Go to DMX Add. main level.
2.
Select the starting address (001–512).
Setting the LED Color
To adjust the color of the LEDs, do the following:
1.
Press <FUNCTION> repeatedly until Color shows on the display.
2.
Use <UP> or <DOWN> to select the desired color (1–21).
Configuration (Standalone)
Use standalone configuration to operate the product without a DMX controller.
Interval
1.
Go to Interval Set main level
2.
Select the desired speed (10-200)
Duration
1.
Go to the Duration Set main level
2.
Select how long the fog flow will last (1-10)
Timer Mode
When in Timer mode, the Vesuvio II will produce fog and light in pre-configured time intervals defined by
the Interval Set and Duration Set menu options. See the Timer Mode Parameters section for details about
how to configure these parameters. To operate in Timer mode, do the following:
1.
Press <TIMER> and the display will show a countdown of the interval timer.
2.
When the counter reaches zero (0), the Vesuvio II will start producing haze and light.
3.
The haze and light output duration during Timer mode is set by the Duration Set menu option.
4.
The color of the LEDs is set using the Color menu option.
5.
This cycle will repeat itself until you press <TIMER> again or until the Vesuvio II runs out of fluid.
Manual Mode
In the Manual mode, the Vesuvio II will output fog and light for as long as <MANUAL> remains pressed.
The output volume will be at 100% full fog and light output.
•
Press <MANUAL>.
This mode will continue until you release <MANUAL> or until the Vesuvio II runs out of fluid.
Vesuvio II User Manual Rev. 2
Color Zone 1
Page 14 of 19
Advertisement
Table of Contents
