Advertisement
H
Select axle brace. Place it between left ends of stand support. Attach it to
supports with two 1/4 - 20 x 5/8" bolts, lock washers and nuts at each end.
Be sure notches are up and narrow flange is toward stand tube.
H
AT THIS POINT, TEMPORARILY INSERT AXLE THROUGH BOTH HOLES
IN LEFT END OF STAND SUPPORT AND AXLE BRACE JUST TO MAKE
SHURE THAT THE HOLES LINE UP.
H
Be sure stand tube and supports are flat on the floor and tighten all bolts
securely.
H
Install a stand foot at the end of each stand support opposite the axle. Be
sure the narrow flanges are nearest the floor and facing each other. Secure
with two 1/4 - 20 x 5/8" bolts, lock washers and nuts. Tighten securely.
GRILL BOTTOM
BRACKET
AXLE BRACE
& AXLE
FIGURE 2
WHEEL
AND PUSH NUT
Step 3.
Refer to Figure 2 Select the following parts for assembly:
1. Axle
2. (2) Push Nut
3. (2) Wheel
4. (2) Axle Spacers
5. Grill Bottom Mount
H
Remove axle from stand support, and install a push nut on one end and seat
it with light hammer taps. Slide a wheel onto axle, now slide a spacer onto
axle next to wheel.
H
Reinsert axle into stand support, then slide second spacer onto other end of
axle followed by wheel and then the pushnut.
H
Be sure to seat the push nut with light hammer taps as before.
H
Attach the grill bottom mount bracket to the top of the Stand Tube with six
1/4 - 20 x 5/8" bolts and lock washers.
STAND TUBE
MID-BRACE
STAND TUBE
STAND FOOT
SUPPORT
Note: The 1/4" plastic wheel spacers go on the
axle between the wheel and the axle brace. They
prevent the wheel from rubbing the axle brace.
C-4
Advertisement
