Chapter 8 Checking Connections; Turning On The Devices; Logical Unit Recognition - Fujitsu ETERNUS Manual

Chapter 8
8.1

Turning on the Devices

To turn on the connected devices, use the following procedures:
1
2
3
8.2

Logical Unit Recognition

Check the state of the ETERNUS Disk storage system LUNs (logical units) using the "format"
command.
Example: ETERNUS2000
# format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
/iscsi/disk@0000iqn.2000-09.com.fujitsu%3Astorage-system.e2000%3A00001001-cm00002,0
/iscsi/disk@0000iqn.2000-09.com.fujitsu%3Astorage-system.e2000%3A00001001-cm00002,1
/iscsi/disk@0000iqn.2000-09.com.fujitsu%3Astorage-system.e2000%3A00001001-cm10004,0
/iscsi/disk@0000iqn.2000-09.com.fujitsu%3Astorage-system.e2000%3A00001001-cm10004,1
Specify disk (enter its number): Specify disk (enter its number):
P3AM-4182-03ENZ0 Server Connection Guide (iSCSI) for Oracle Solaris
Checking Connections
Procedure
Turn on any devices (such as LAN switches) on the LAN path between the
ETERNUS Disk storage system and server.
After checking that the Ready (or equivalent) LED of the LAN switch is lit, turn on
the ETERNUS Disk storage systems.
After checking that the ETERNUS Disk storage systems' Ready LED is lit, turn
on the server.
1. c6t25d0 <FUJITSU-E2000-0000 cyl 510 alt 2 hd 64 sec 256>
2. c6t26d0 <FUJITSU-E2000-0000 cyl 510 alt 2 hd 64 sec 256>
3. c6t27d0 <FUJITSU-E2000-0000 cyl 510 alt 2 hd 64 sec 256>
4. c6t28d0 <FUJITSU-E2000-0000 cyl 510 alt 2 hd 64 sec 256>
23
End of procedure
Indicates connection
via "CM0"
Indicates connection
via "CM1"
Copyright 2010 FUJITSU LIMITED