Iscsi Basic Settings - Fujitsu ETERNUS Manual

Chapter 7 Installing the iSCSI Software Initiator and Setting Up the Server
> 7.2 Setting Up the Server
7.2.2

iSCSI Basic Settings

The following operations are required for iSCSI connection.
• Checking the iSCSI Initiator
• Checking the iSCSI Initiator Node Name
• Setting the iSCSI Target IP addresses
• Enabling the iSCSI Target connection
• Creating an iSCSI device link
• Checking the ETERNUS Disk storage system
Procedure
1
2
3
P3AM-4182-03ENZ0 Server Connection Guide (iSCSI) for Oracle Solaris
Check that the iSCSI Initiator service (iscsid) is enabled.
# svcs -a | grep iscsi
disabled 14:30:33
If the iSCSI Initiator service is "disabled" (the default setting), use the "svcadm" command
to change it to the "online" state.
# svcadm enable iscsi/initiator
# svcs -a | grep iscsi
disabled 14:30:33 svc:/system/iscsitgt:default
online 14:30:33 svc:/network/iscsi/initiator:default
Check the iSCSI Initiator Node Name.
Use the "iscsiadm" command to check the iSCSI Initiator Node Name.
This name is used for the ETERNUS Disk storage system settings.
# iscsiadm list initiator-node
Initiator node name: iqn.1986-03.com.sun:01:0003bace9997.48a386c4
Initiator node alias: -
Login Parameters (Default/Configured):
Header Digest: NONE/-
Data Digest: NONE/-
Authentication Type: NONE
RADIUS Server: NONE
Configured Sessions: 1
Set the iSCSI Target IP address(es).
To connect the iSCSI Target, specify the IP address of each iSCSI CA port of the
ETERNUS Disk storage system that is to be an iSCSI Target, as a "discovery-address".
# iscsiadm add discovery-address
svc:/network/iscsi/initiator:default
IP_address
17
Copyright 2010 FUJITSU LIMITED